Surface Cleaners

INDASOL have a complete range of surface cleaning products. To discuss your needs and answer any questions, please contact us on the details below.

Surface Cleaners Product Range:

The following is a sample of the types of products we offer:

Isopropyl Alcohol (IPA):  this is an alcohol based, residue free cleaner designed for removal of greases, finger marks and general contamination from substrates.

DSI: adhesive remover and high performance degreaser.

Antibacterial Surface Wipes – Multi Task
Helps reduce the spread of bacteria. Ideal for quickly and easily cleaning up hands, tools and most surfaces without the need for water.
Designed to remove wet paint, wet PU foam, adhesives, tar, sealants, fillers, grease, grime, oil, asphalt, lubricants and everyday soiling.
The tough, absorbent and recyclable wipe material contains anti-bacterial properties. Dermatologically tested.

FUSION Cleaner – Plastic adhesive remover and cleaner
– Used to remove fresh acrylic adhesive errors, runs, finger marks, etc
– Use via a clean lint free cloth
– With a one wipe application
– Non-flammable
– Datasheet: FUSION CLEANER – SDS10533

FUSION Surface Prep – Plastic Preparation Cleaner
– Rapid drying prep fluid
– Leaves a squeaky clean surface prior to printing or bonding
– Use with a clean lint free cloth
– Datasheet: FUSION SURFACE PREP – SDS10561

ANTISPEX – Anti-Static All Plastics Cleaner
– Anti-static cleaner for all plastics including polycarbonate
– Removes soiling and marks
– Leaves a static-free finish
– Rapid drying

SIGN WASH – Cleans & Enhances Signage
– Deep clean for signs
– Used on all types of signage
– Spray on, hose off
– Enhances and revitalises
– Hard and soft signage
– Datasheet: SIGN WASH – SDS10577

When working with Tapes, Adhesives, Sealants, UHBs or any bonding product, it is vital that the surface is cleaned correctly. Each surface needs to be free from dirt, grease and contamination prior to bonding. In some cases a primer may be required and it is critical that the correct primer is used. It may also be the case that light abrasion is required to help the bonding product key into the surface.

Due to the changing raw material content and surface finishes of some substrates, it is essential that all of our adhesives and tapes should be tested by the customer to ensure substrate and performance compatibility for each application. Please contact us for any advice. We do not accept any liability for product failure.

In some cases certain surfaces are not suitable for using the above cleaners and primers. Please check with our Technical experts for compatibility.

When using UHB products, cleaning and priming is normally advised.  Visit our UHB Application Guide for more information.

Find out more and Get a Quote Today

Contact Us
Product specifications referring to the mentioned properties are typical and do not imply specifications limits or guarantees.
These values may be changed at any time without prior notice. Please consult with Industrial Adhesive Solutions Ltd to confirm actual values.

The information reported in this webpage has been carefully checked and is believed to be accurate. Although it reflects our knowledge and belief, the Company will assume no responsibility for any errors or omissions, damage or loss resulting thereof. It is necessary to verify any recommendation for use as regards the suitability and conformity with actual project requirements, specifications and any applicable law.